Rooftop Surveillance Tower Mounted Without Roof Damage
A logistics park with no land left puts its cameras on the roof and finds the roof is the problem: parapet wind runs 30% stronger than at ground level, the membrane cannot be drilled, and no drawing says which beam will carry a tower. This rooftop monitoring steel tower is built for that interface: a counterweighted base spreading 3.2 m² without cutting the membrane, and a foot tied to the beams where drawings allow. The frame is a signal supporting surveillance tower in three sections light enough for a staircore winch; the remote sensing surveillance tower variant adds a stabilised plate and a data route kept clear of the camera feed.
Point loading, not wind, is what ends most roof installations. A 240 kg section standing on four small pads puts a load on one beam that no roofing warranty will cover, and the repair is a new membrane over a new slab.
Product Specifications
Parameter
Specification
Roof load
6.1 kN per leg m…